The PC16DO module has 16 open drain MOSFET (N-TYPE) digital outputs. The outputs may be used to drive lamps or external relays when more drive capability is required. The outputs are isolated from the logic and they share a common negative terminal. Each output is protected against over current and voltage.
The module plugs into a special bus connector which fits inside the DIN rail. The power supply voltage and the CAN bus signals are connected via this bus connector.
The CAN interface is electrically isolated and is compliant with ISO 11898.
The module has been equipped with status led’s which are used to indicate the status of the Inputs and communications. This visual indication assists with fault finding and diagnostics.
The CANopen node ID and bit rate can be setup by DIP switches or software.
|Power Supply||Logic Supply Voltage||12 -24 Vdc|
|Logic Supply Current||37mA @ 12V / 21mA @ 24V|
|Field Supply Voltage||12 -24 Vdc|
|Field Supply Current||6mA @ 12V / 6mA @ 24V|
|Digital Outputs||Output Points||16|
|Maximum Voltage||48 Vdc|
|Maximum Current||0.5A per output|
|On-state resistance||0.55 ohms|
|Output update rate||< 1ms|
|Isolation||1500Vrms between field and logic|
|Error Control||Node Guarding / Consumer Heartbeat|
|Node ID||DIP switch or software|
|Number of PDO||1 Rx|
|PDO Modes||Event Controlled Asynchronous,
Event Timer Asynchronous,
Sync – Acyclic, Sync – Cyclic.
|Number of SDO||1 Server|
|Temperature||Operating Temperature.||-20°C to + 70°C|
|Storage Temperature||-40°C to + 85°C|
|Connectors||Logic Power and Comms.||5 way connector that clips onto DIN rail|
|Inputs||6 x 3 Way screw connector on top and bottom|
Fill in your details below for more information on this product.