PC6RO – 6 Relay Output Module

PC6RO – 6 Relay Output Module

The PC6RO module has 6 normally open/ normally closed relay outputs. These modules may be used when a higher drive capability is required, or when isolation between outputs are required.

The module plugs into a special bus connector which fits inside the DIN rail. The power supply voltage and the CAN bus signals are connected via this bus connector.

The CAN interface is electrically isolated and is compliant with ISO 11898.

The module has been equipped with status led’s which are used to indicate the status of the Inputs and communications. This visual indication assists with fault finding and diagnostics.

The CANopen node ID and bit rate can be setup by DIP switches or software.

 

 

 

Power Supply Logic Supply Voltage 24 Vdc
Logic Supply Current 71mA
Relay Outputs Output Points 6
Maximum Current 1A  @ 220VAC / 1A @ 28VDC
Isolation 4000Vrms between field and logic

1500Vrms between outputs

CANopen Data NMT Slave
Error Control Node Guarding / Consumer Heartbeat
Node ID DIP switch or software
Number of PDO 1 Rx
PDO Modes Event Controlled Asynchronous,

Event Timer Asynchronous,

Sync – Acyclic, Sync – Cyclic.

PDO Mapping Variable
PDO Linking Supported
Number of SDO 1 Server
Error Message Yes
Temperature Operating Temperature. -20°C to + 70°C
Storage Temperature -40°C to + 85°C
Connectors Logic Power and Comms. 5 way connector that clips onto DIN rail
Inputs 6 x 3 Way screw connector on top and bottom

Order Code

  • PC6RO CANopen 6 Relay Output Module

PC6RO - CANopen 6 Relay Output Module

Fill in your details below for more information on this product.