The PM8DIO module is an 8 channel digital input and 8 channel digital output module.
The inputs are isolated from the logic by bi-directional opto-couplers. The common is connected internally to either the -volts or +volts field power supply terminals using a jumper link which is situated inside the housing.
The module may be used as either a slave or master on the Modbus network. When used with a PC or PLC the module will be configured as a slave. When used with another PM8DIO module in a point-to-point configuration, the DIP switch 9 must be turned on to set the module up as a master. In this mode the PM8DIO module will automatically read/write the information from/to the other PM8DIO module.
The inputs have internal counters associated with them. These counters are 32 bit counters allowing a count value from 0 to 4294967295. The count value can be cleared by writing a zero to the associated registers or preset to any other value using the same method. The counters can also be reset automatically when read. This is done by setting on DIP switch 9 on the front panel.
Note: The count values are not battery backed-up and will be lost if power is turned off.
|PM8DIO – 8 DIGITAL INPUTS / 8 DIGITAL OUTPUTS|
|Counter Resolution||32 Bit|
|Counter frequency||1 KHz (max)|
|Pulse width||500usec (min)|
|Counter Mode||UP or UP/DOWN|
|Digital input 0 level||0 to +6.5Vdc|
|Digital input 1 level||+12Vdc to +24Vdc|
|Input Impedance||2200 ohms|
|Input filter||Max 6553 msec.|
|Status Indication – inputs||LED per channel|
|Type||NPN Open collector|
|Max Load Current||100mA per channel|
|Max load Voltage||36Vdc|
|Vce (on) Voltage||1.1V (max)|
|Isolation (Field & Logic)||1500VAC RMS|
|Watch dog output timer||Disable or 1-255 sec adjustable|
|Isolation (Field & Logic)||1500 V RMS|
|Status Indication – outputs||LED per channel|
|Power supply (Field)||+12Vdc to +24Vdc|
Fill in your details below for more information on this product.